« previous next »
Pages: [1]   Go Down

Author Topic: TX-P42S10B 5 led flash error  (Read 5450 times)

0 Members and 1 Guest are viewing this topic.

buggsy

  • Full Member
  • ***
  • Posts: 44
    • Email
TX-P42S10B 5 led flash error
« on: July 23, 2012,15:16:46 »
TX-P42S10B

got in a this plasma tv in error 5 led flash indicated 5v sos by panasonic service manual indiscates replace the  A  board.

checked on net someone posted changed ysus board fixed fault.

if unplug ysus get 7 flash error then reconnect get the original 5 flash any ideas as donot want to purchase wrong board also ysus is out of stock every where at the moment.
Logged

Mulja tv repair portal

TX-P42S10B 5 led flash error
« on: July 23, 2012,15:16:46 »

jordan

  • Hero Member
  • *****
  • Posts: 896
Re: TX-P42S10B 5 led flash error
« Reply #1 on: July 23, 2012,15:37:28 »
Error code 5.........X-SUS board
Logged
Greeting from Slovenia
Jordan Čebron

downunder

  • Hero Member
  • *****
  • Posts: 1200
Re: TX-P42S10B 5 led flash error
« Reply #2 on: July 24, 2012,06:23:00 »
Tread with care, buggsy. SC board can cause SOS code 3, 4, 5 or 7, and is most likely suspect. Ohms check pin 1 of the SC connector (Vs) to ground - power off of course - on the SC board. Good chance it'll read short circuit.
Logged

Mulja tv repair portal

Re: TX-P42S10B 5 led flash error
« Reply #2 on: July 24, 2012,06:23:00 »
Pages: [1]   Go Up
« previous next »
 

download
download
download