Forum > LCD TV forum

Philips Option Code change

(1/2) > >>

gsmgsa:
Hello everyone!

       I wonder if there is any possibility to change option code for Philips LCD TV 32PF9830/10 without ComPair II interface.
      I changed my option code for this tv set from ethernet off to ethernet on, although I noticed afterwards that tv doesn't have an ethernet port installed on SSB, and now set doesn't want to turn on anymore. Is there any way I could change that option or any software I could like... boot with in order to  do this, or can it be  changed again somehow from the RC without comPAIR? I tried with firmware upgrade but no luck. Thanks for any input.

jagbogah:
Hi get the Erprom IC reprogram with new file.
Good luk.

ANDRASONI:
Try this:

gsmgsa:
Thank you, u my tv is 32PF9830/10. Are you sure this is the same Option Code as for PF9830/10? Thanks a lot.

astracat:
hi option code is on sticker on tv, look on main board for boot up conection short out while power upthen correct its option code
astracat

Navigation

[0] Message Index

[#] Next page