Forum > PLASMA TV forum
Panasonic TX-P50X20B blinking
downunder:
If it has fans, one may be clogged up. If fans still not operating after cleaning, blame the A-Board.
Or as Jordan says, it could be the SC-Board. Or P-Board can also cause Code 10. Service manual points the finger at A-Board, SC-Board, SS-Board and P-Board, but these codes are not to be taken as gospel, as I've found out on a few occasions.
Simisker:
Yea I've looked at the service manual, and looking at changin. The SS board, I'll attach the info from Panasoni. Now.
"On bench fault seen shuts down 10 flashes S/C on SS PCB also SC PCB has to be disconnected for VSUS to come up. Will est. for both boards SS PCB TXNSS1LNUC"
downunder:
Well Simi, here a Code 10 troubleshooting chart for you to digest.
Simisker:
That's amazing downunder, thank you hopefully it will sort the tv out
Simisker:
How would I fix ic9801 and also how would I fix the f+15v?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version