Sharp LC-26AD5E - P/S problem.

[Turnip]

Hi folks,

Had one in that went straight to Green LED but set didn't work. Noticed with the 32 inch version a Quuq chap suggested F404(1.6A) probably O/C and also IC404(KIA431A-AT) should be checked.

F404(1.6A) (main Tx 12v O/P) was O/C, so replaced, set then worked, but couldn't see the link to IC404 on S/by feedback.

Only mention out of interest - Chris.

[downunder]

Hi Chris,

I'd venture to say that said chap is having a lend of you.......can't see any connection with IC404.

Bruce

Service manual added to quuq downloads.

[Turnip]

Hi Bruce and thanks, suspected might be the case, my diagrams were horribly difficult to read.

Just for fun, tried read Eeprom on a CV109H MB where set was doing odd things. Took maybe 40 attempts with the clip to get a reading - seemed OK compared with a held bin, but then found set was stuck in S/by.

Later discovered I'd knocked off L11(SMD) attempting read the chip, guess any SMD chip inductor might do, as shematics aren't to be had.

All fun - Chris.

Later - Replaced L11 with something off another board, found things the same, so changed Eeprom for a similar model - All OK apart from solarisation - Murphy C3298F from Cello C3298F - same panels and screen - So it goes.