Author Topic: samsung ps50Q96HD  (Read 207 times)

0 Members and 1 Guest are viewing this topic.

t1412

  • Hero Member
  • *****
  • Posts: 807
    • Email
samsung ps50Q96HD
« on: March 02, 2019,14:06:49 »
Hi fella's just been to a pub to look at this tv,  it's a samsung ps50q96hd clicking fault , took the back off 3 caps were gone, dry joints on the 2 fets replaced cleaned up, but still clicking when it does boot up crackerling sound half a picture, i have had this fault before i replaced the mainboard cured the fault, is there a repair on the mainboard i can do instead of replacing the board thanks

shaun     

Mulja tv repair portal

samsung ps50Q96HD
« on: March 02, 2019,14:06:49 »

chris333j

  • Newbie
  • *
  • Posts: 9
    • Email
Re: samsung ps50Q96HD
« Reply #1 on: June 10, 2019,07:48:11 »
Hi have you check the vs, ve, vcc... ?

downunder

  • Hero Member
  • *****
  • Posts: 1027
Re: samsung ps50Q96HD
« Reply #2 on: June 11, 2019,03:26:49 »

If the two FETs were QX801/2, you need to check RX802, RX803, RX832 and RX833. These are all 20 ohm smd. RX803 is across RX832.
Also check RX804 (10K) - usually OK. Can also kill DX803 and DX804. If in doubt about any readings, this circuit is replicated on the print side of the 2 larger FETs on the same heatsink - compare.                                Bruce

Mulja tv repair portal

Re: samsung ps50Q96HD
« Reply #2 on: June 11, 2019,03:26:49 »

 

Powered by EzPortal