Author Topic: LOGIK LCXW32HD1 (Read 7298 times)

Dansford · « **on:** March 19, 2010,12:16:00 »

Hi, I have a LOGIK LCXW32HD1 LCD TV which is dead. Every internal fuse installed is blown. I have replaced the FSD200 on the power supply board but it continues with the same problem.

Any input would be much appreciated!

Thanks in advance

Dansford

Mulja tv repair portal · « **on:** March 19, 2010,12:16:00 »

Turnip · « **Reply #1 on:** March 19, 2010,13:18:00 »

Hi Dansford,

There's usually more than that exploded FSD200 to replace. Most suppliers have a kit with lots'a bits - done some myself. Phoenix kit from Grandata, Wiltsgrove or wherever - OK - Chris.

tv john · « **Reply #2 on:** March 21, 2010,04:39:57 »

Hi guys, check mains smoother as well.

John

Mulja tv repair portal · « **Reply #2 on:** March 21, 2010,04:39:57 »

michael first · « **Reply #3 on:** March 21, 2010,05:15:50 »

Hi,this could help.Good luck.

Dansford · « **Reply #4 on:** April 15, 2010,08:33:19 »

Hey, I replaced the smd bridge rectifier on the underside of the board but still same problem. As far as I am aware the FSD200 and DBS106G bridge rectifier are the common source of blowing fuse. I have tested the other components suggested by the repair kit but they all seem functioning.

Any more input would be appreciated !

I'll probably have to buy a repair kit - does anyone know which sites are good for repair kits, I have found a few but they cost more than the TV :wacko:

sparky · « **Reply #5 on:** April 15, 2010,10:42:23 »

what more than £20 tv didn't cost much then, try ohmsupplies fit the
correct one should cure the fault

Mulja tv repair portal · « **Reply #5 on:** April 15, 2010,10:42:23 »

Mulja tv repair portal

News: