Author Topic: Bush IDLCD32TV05HD beko psu Z1J.194-04 dead no standby (Read 11111 times)

Tmg · « **on:** September 09, 2010,19:02:56 »

Hello
I have this bush for repair it is dead, found 4x 1000uf caps bulging on the 12v line (replaced)
I have also tested for the following with no luck
R954, D909, IC901, all ok
To test psu add 6v2 zener from pin 2>1
there are 2 outputs on this psu 24v comes up and after a while dies away
and 12v (pin 2) only comes up to 1.3v
This psu has sprung into life once and ran with good output voltages.
I have swapped components over from the 12v psu to the 24v psu which are the same with still no luck.
Can anyone help,
or does anyone have a manual for this
Regards
Tony.

Mulja tv repair portal · « **on:** September 09, 2010,19:02:56 »

Turnip · « **Reply #1 on:** September 11, 2010,12:46:23 »

Hi TMG,

What is it - well, few numbers or piccies - our Sparky might get distressed (he's an info man - others do it with table tapping) - Chris

Contrast John · « **Reply #2 on:** September 11, 2010,13:17:33 »

Hi Tmg
Have attached file of psu
Regards
John.

Mulja tv repair portal · « **Reply #2 on:** September 11, 2010,13:17:33 »

EARLYBIRD · « **Reply #3 on:** September 11, 2010,14:52:15 »

Hi.Solder all the sockets they are terrible for dry joints should cure problem.These connections can cause allsorts of intermittent problems.

Tmg · « **Reply #4 on:** September 11, 2010,16:47:13 »

Thank you John for the psu circuit now I can crack on and check all the rest of the components that I was unable to swap of to the 24v psu side.
I have also resoldered the whole pcb with no luck.
Chris Much table tapping was done on this thing certainly wont forget this one= (The 3 years out of the trade means I have a lot of catching up to do these days)
Regards
Tony.

Turnip · « **Reply #5 on:** September 14, 2010,11:45:34 »

Hi Tony,

Would almost kill for a piccy of P/S, would swap with Sparky for half his 'Woodbine'airship collection - (not a word though - Chris)

Mulja tv repair portal · « **Reply #5 on:** September 14, 2010,11:45:34 »

Tmg · « **Reply #6 on:** September 14, 2010,15:42:55 »

I have decided to replace the damn psu, The downloaded circuit has some different component values and locations,
And to keep Chris happy here is a picture
http://www.chsinteractive.co.uk/electrical-components/lcd-plasma-spares-repair/lcd-pcb-power-supplies-boards/fits-32-inch-lcd-tv/z1j194-11-pcb-psu-32-inch-beko-with-7-pin-socket-only.htm
I couldnt upload a picture
Regards
Tony

Turnip · « **Reply #7 on:** September 15, 2010,11:53:00 »

Hi and thanks Tony,

Piccy rather like a failed omlette - well that's ChasHyde for one. Will hunt about for the real McCoy - Chris.

Mulja tv repair portal · « **Reply #7 on:** September 15, 2010,11:53:00 »

Mulja tv repair portal

News: