Author Topic: SHARP LC32D44EBK 32 stuck in standby (Read 27274 times)

blackmail · « **on:** September 10, 2010,11:39:32 »

SHARP LC32D44EBK 32, I have one of these tv that is stuck in standby. i have checked the power suppy/ inverter board number runtka396wjn1 and i get standby voltage. but when the relay comes in it just go's to a reset or safety circiut

Mulja tv repair portal · « **on:** September 10, 2010,11:39:32 »

stellaman · « **Reply #1 on:** September 10, 2010,15:44:21 »

Follow previous posts for Chrissis Jones' problem.

Dave

astracat · « **Reply #2 on:** September 10, 2010,15:50:00 »

hi see if will come on in service mode input &vol - while plugin in if so cheque lamp error code should be 0
sounds like an inverter problem ,have one earlier model with same symptons turns out to be control ic on inverter panel
astracat

Mulja tv repair portal · « **Reply #2 on:** September 10, 2010,15:50:00 »

blackmail · « **Reply #3 on:** September 11, 2010,06:32:21 »

Quote from: stellaman on September 10, 2010,15:44:21

Follow previous posts for Chrissis Jones' problem.

Dave

could you please give me a link to the thread coz when I search I only get this thread

i will check enginners mode now

blackmail · « **Reply #4 on:** September 11, 2010,08:45:51 »

tried to send it to test mode and the backlight flashes on then goes off

Contrast John · « **Reply #5 on:** September 11, 2010,12:28:56 »

Hi blackmail
Here's a link to earlier postings-should enable you to overide the backlight protection and locate the problem.
http://www.tv.quuq.org/forum/index.php?topic=2801.0
Regards
John.

Mulja tv repair portal · « **Reply #5 on:** September 11, 2010,12:28:56 »

Mulja tv repair portal

News: