Author Topic: SONY KV-32FX68U (Read 7453 times)

chrissie jones · « **on:** March 23, 2011,04:15:45 »

got this tv comming in today.wen switch flashes 4 times only.any idears lads.

Mulja tv repair portal · « **on:** March 23, 2011,04:15:45 »

Keith · « **Reply #1 on:** March 23, 2011,07:50:31 »

RGB chips cause problems, Q8121 on D board, dry joints on the processor or the processor itself, Q8805 (BUZ90 works) and or LOPTX, or either of the MCZ3001D chips or it may be as simple as dry joints on the field chip!

Good luck

Keith

chrissie jones · « **Reply #2 on:** March 23, 2011,08:28:54 »

thanx keith..

Mulja tv repair portal · « **Reply #2 on:** March 23, 2011,08:28:54 »

Κώστας · « **Reply #3 on:** March 23, 2011,10:27:37 »

The KV-32FX68U is AE-6B chassis and 4 led code the error message is "no vertical sync".

Κώστας · « **Reply #4 on:** March 23, 2011,10:36:15 »

Probably opened resistors R8835 (0R47) R8834 (0R47).

Turnip · « **Reply #5 on:** March 23, 2011,12:14:26 »

Yes but,

Dead, flashing error code for no field synch. Misleading because there was no line drive due to L/Driver Tx T8802 being open circuit, therefore no line and no field.

One from the old TV mag files - Chris.

Mulja tv repair portal · « **Reply #5 on:** March 23, 2011,12:14:26 »

Keith · « **Reply #6 on:** March 24, 2011,03:55:26 »

I have always found the auto diagnostic codes misleading. The faults I listed above can give any code, even unlisted codes, very useful. However, 4 flashes usually point to a vertical problem or something else!
I am sure Chrissie has it sorted, if he has a fork lift to move it!

Keith

chrissie jones · « **Reply #7 on:** March 24, 2011,03:57:45 »

ant worked that one out yet keith.

Mulja tv repair portal · « **Reply #7 on:** March 24, 2011,03:57:45 »

Mulja tv repair portal

News: