Bush A642F - main board problem ?

[Turnip]

Hi folks,

Have one of these that comes on on BBC1 perfect sound and picture but - neither RCU or set buttons work. Blue led flashes in sympathy with RCU. Unplugged local buttons in case of tact problem but no dice.

Any hope ?  Chris.

PS - Main board is 715G3462-1  Power/Inverter 715G3511

[brainstorm]

Hi Chris

Sounds like it needs a service mode reset, but I don't know how you access it

I found this on the 'other' site so you can try it:

"Press and hold Menu button on front panel for about 5 secs, release the menu button and then press the menu button on the remote control. Note apply above operations to toggle between remote on and off"

Im not sure it makes a lot of sense but worth a shot

Happy Christmas

Brian

P.s Bah Humbug

[Turnip]

Thanks Brian,

Will give it a go -

PS - Beware Crimble nocturnal 'visitations' - even at your age - Tiny Turnip

[Turnip]

Hi Folks,

Thought to update this one as entering A642F on the interweb brings up similar problems where RCU and set buttons don't work.
Got a screen smash panel on Ebay and now set works well on it's buttons - RCU still giving blue flash on set but nothing else - Wilts don't yet do an RCU but suspect prob might be elsewhere.

PS. Thanks Brian for that other-site info - as you had guessed, it does nothing useful but kept me busy pre Crimble - Chris.

[fix2003]

on A626 version
Bush A626 no remote functions
You can disable the remote control and/or the user control buttons on the set.
 
A few ways to get out of this.

Press Menu button for 10 seconds on remote control to enable/disable remote functions.

Press the Menu button on the tv to enable/disable the TV user controls on the set.
 

[Turnip]

Hi F-I-N, nice one, will give it a go - reply tomorrow,

Forgot to mention that on pressing 'Menu' on the set - after board change, cursor buttons on RCU worked, enabling a full reset and re-tune - even RCU S/by button functioned.

Out of 'Menu' no RCU buttons work - some strange Bush - Thanks again - Chris

[Turnip]

Hi FIN and many thanks,

Was doubtful but it did the biz -   - My first Quuq emoticon, ever  - Thanks again - Chris

[old tvman]

Anyone know how to enter the service mode for this model, I have a similar problem to the above posts,Will go into standby with the remote control but wont come out of sby with remote or keypad (have to switch of at mains and reconnect whilst holding keypad sby button) set comes on and all remote functions work but no operations on  keypad.
thanks davy

[jordan]

This appliance use chassis 715G34621/China
All instruction in page 53
!!! Press and hold MENU button on front panel for about 5 sec,release the MENU button and press the MENU button on RC.Apply above operations to toggle between remote ON/OFF

[old tvman]

Cheers jordan ,much oblidged will try this later.
thanks davy

[t1412]

hi, the mainboard is a haier to enter the service mode 8893 or 062596 plus display/info, p mode, s mode it's on this site somewhere thanks ps it's menu 8893

regards
shaun  

[old tvman]

MENU 1999 got me in to the service menu, I did a factory reset and now I have no remote functions and no on screen graphics I suspect the uprocessor is goosed.
Thanks for the replies davy.