Forum > LCD TV forum

goodmans RF fault

<< < (2/3) > >>

sabre504:
Have you checked the output voltages on the psu ?
Paul

pc:
Hi. Paul,
No I havn't checked it yet,(I don't know how to but by neighbour is an electronics engineer so I will get him round hopefully later today to do the test) they reply
Thanks
PC

sabre504:
HI well ask him to check volt regulators on the main board as well if he wouldnt mind .

As you said it worked for a while then stopped working again, had the same problem on a set that if you unplugged it for a couple of hours it would work until you turned it off then it wouldnt come back on again until you left it unplugged for another couple of hours.
That was a regulator that caused it worth a check or as sparky said could well be a software issue
Paul

pc:
Hi,
I have resolved the problem, which wasn't really a problem at all
I started again from basics and found that I had sourced "TV" instead of "DTV" on the television
So I corrected that and re-tuned both the TV and the recorder and now have a perfect picture.
Could the fault that I had, have resulted in changes still taking place with the incoming RF signal at the time I lost the picture? as prior to that point I had no problems, and I changed over from analogue to digital last September or so I thought!!
Anyway, thanks for your input and I have learn't again that "back to basic's" is always the right option
Paul C

sabre504:
Glad you sorted
Paul

Navigation

[0] Message Index

[#] Next page

[*] Previous page