Forum > LCD TV forum

LE32R88BDX/XEU - V315B1-C01 - Solarisation.

<< < (2/3) > >>

Turnip:
Hi Bruce,
Absolutely right again - An AS15-G chip lurking on the t-con - Thanks - Chris.

PS - And they're cheap at a quid, just a bother to change without wreaking the print.

downunder:

Hi Chris,

Thought you were more fastidious than that....."wreaking the print"......or have you partaken of the turnip wine again. And you actually edited your post.

However, I do agree, especially those that had a copper pad on the underside of the IC. Recently tried to remove one on an el-cheapo brand where I had to apply so much heat that the surrounds of the chip were totally demolished. But, trying as always to earn the needy moolah.

Bruce

sparky:
Hi think emos do a repair service

Turnip:
Hi Bruce and Sparky,

'Natch I meant reeking havoc print-wise, but confess had the spell thingy turned orf. Note that chap of Flea mends them but will check Emos - Thanks again - Chris.

PS - Hope not a copper pad, last one I had was on a Pure One Mini, where managed to get the miniscule audio chip off OK, but no way could re-solder the pad, even with LMP solder and several print-through holes. Other problem in that case was the 8 pins didn't extend from the underside of the chip, so not sure if I'd got at them at all - Fun though.

Much later - Got the chip for 99p and of course it has the heat sink pad, so doubt I can sort it without serious gear, as guess needs 300+C to get it off the panel using Lead Free solder, as can't float LMP under the chip to free it.

Think to check out serious gear, but as only have a few such per year, and the panels are all of different dimensions, guess would take some time to make a profit, unless I stick to T-cons using this notorious chip.

Think bite the bullet this time, get a good T-con from The Flea, and make only a modest profit, even though the thought of £30+ for a T-con mend still seems attractive.

downunder:

Hello Sparks,

We don't have emos over here in the antipodes. We do have emus, however. Not sure if they have any talents, though.        Bruce

Navigation

[0] Message Index

[#] Next page

[*] Previous page