Recent Posts21
LCD TV forum / Re: Faulty screens
« Last post by downunder on October 21, 2023,06:36:29 »Greetings Al,
Shows how far the quality level of displays has sunk. There are several you tube videos on this tape method. Sure, it works sometimes but I have found it somewhat tedious finding the right pins to block. Can give acceptable results but the quality of the picture
is usually degraded a tad.
Of course, if you can determine which half of the panel is defective it narrows things down. Not always possible as some sets use only one flexie from the main board to panel, but with other sets you can disconnect the t-con to panel flexies individually. One scenario should produce half
a good screen. If the half you've disconnected is bad, and unplugging that good half and connecting the "bad" half will get you back to a blank screen.
If you've reached this point, first check the smd caps on the bottom driver board for shorts. Some Samsungs have a cluster of 6 or 8 diode packs at the extreme outer ends of the driver boards which sometimes short. These are microscopic 10 pin devices like dual in line ICs D01, D02 etc. The centre pins (3 & 8) are common earth for the 8 encapsulated diodes. If you find one that has a shorted diode, simply desolder it and leave it out.
Hopefully this gives you some inkling. Bruce
Shows how far the quality level of displays has sunk. There are several you tube videos on this tape method. Sure, it works sometimes but I have found it somewhat tedious finding the right pins to block. Can give acceptable results but the quality of the picture
is usually degraded a tad.
Of course, if you can determine which half of the panel is defective it narrows things down. Not always possible as some sets use only one flexie from the main board to panel, but with other sets you can disconnect the t-con to panel flexies individually. One scenario should produce half
a good screen. If the half you've disconnected is bad, and unplugging that good half and connecting the "bad" half will get you back to a blank screen.
If you've reached this point, first check the smd caps on the bottom driver board for shorts. Some Samsungs have a cluster of 6 or 8 diode packs at the extreme outer ends of the driver boards which sometimes short. These are microscopic 10 pin devices like dual in line ICs D01, D02 etc. The centre pins (3 & 8) are common earth for the 8 encapsulated diodes. If you find one that has a shorted diode, simply desolder it and leave it out.
Hopefully this gives you some inkling. Bruce